Theoretically, both methods are feasible, but because the routing bit is subject to a large lateral force, if the welding method is used, the quality control must be quite good. Each method is different, and the unit price is also very different. Traditional tool factories have emphasized on one-piece construction. Without joints, better mechanical stability can be obtained, and the strength will be relatively stable. However, under the consideration of cost and technology, the drill bit began to be produced by welding structure, but it is not clear whether this method can be used stably in the milling cutter.
In terms of drill pins, the industry has standardized methods, and the usage is relatively large, so the unit price is relatively low and the difference is small. However, in terms of milling cutters, there will be large changes due to factors such as the pattern of the knife pattern and the diameter.
Because of the influence of production time, procedures, demand, etc., the price difference is not small, and it is more controversial in terms of quality. At present, certain manufacturers harden the surface of the tool, which can greatly extend the life of the tool. This situation causes greater changes in the quality comparison. Because the milling cutter cutting operation method and product specification requirements will affect the cost of manufacturers, some manufacturers will use whether to use it in sections on the calculation basis, and convert the forming knife to a plate cutting mold to calculate the cost separately. Cost concept.
From the above description, it should be understood that the price and cost of such tools cannot be evaluated solely by selling price, and the quality judgment may not be judged by a single case. It is more recommended to consult with the manufacturer, which is more practical. The above is for your reference.
